Remove the speaker connector boards:
1.Release the ZIF connector (1) to which the left speaker connector board cable is attached, and then disconnect the left speaker connector board cable from the system board.
2.Remove the three Torx T5M1.3×3.7 screws (2) that secure the left speaker connector board to the back cover.
3.Remove the left speaker connector board (3).
NOTE: If the power (1) and volume board actuators (2) should become displaced during the removal of the left speaker connector board, install the actuators into the openings in the back cover as indicated in the following illustration. The power and volume board actuators are included in the back cover spare part kit, spare part number
22 | Chapter 5 Removal and replacement procedures |
