4. printing testing
Switch on the power | press the power key | During printing, pls keep the |
|
| Cover of the printer open, just |
|
| insert the paper to the hole as |
|
| picture shows. Then no need to close |
|
| the cover. |
Cleaning the cartridges and checking the printing quality. If the printing is uncontinuous, maybe for there is little air in the nozzle. And after several times of cleaning, there is still some uncontinuous condition, especially for the single color, you can keep the printer for about one hour, the printer will be ok then.If after testing, still unnormal, you can solve the problem as follows: ( set the color cartridges as an example)
There is air in the tube, and can not be solved by cleaning
Put out the cartridges and put in the pedestal, install it on the end with hole
convert the cartridges, keep the end with hole up and let it in the same level of the ink tank.
As picture shows, the up hole is for Magetta, “c”means cyan, “y”means Yellow.
When you want to draw one of the color, you should put on the rubber for other Holes.
Put the inkjector to the hole that you are going to draw air out
Pull up the plunger | Till there is ink up | In the same way, draw out the air for other |
|
| color cartridges, then there will be no air |
|
| in the tubes. |
