chapter 2

load an original photo on the glass

You can make a copy of an original photo from the glass of your HP psc. It is important that you load the original photo on the glass properly to get the best possible copy.

1Load your original photo face down on the left front corner of the glass.

Position the photo on the glass so the long edge of the photo is along the front edge of the glass.

load originals & paper

2Close the lid.

For more information on special copy jobs, or making borderless copies of photos, see perform special copy jobs on page 20.

load letter or A4 paper

The following describes the basic procedure for loading letter or A4 paper into the HP psc. For best results, adjust the paper settings each time you change paper types or paper sizes. For more information, see set the paper type on page 15, and avoid jams on page 16.

Note: There are specific considerations for loading certain types of paper, postcards, and envelopes. After you review the procedure for loading letter and A4 paper, see load envelopes on page 14, and load postcards, Hagaki cards, or 4 by 6 inch (10 by 15 cm) photo paper on page 14, and load other types of paper in the paper tray on page 15.

1Lower the paper tray, and if necessary, slide the paper-width guide to the outermost position.

2Fold out the paper-tray extender to catch paper as it exits the device.

Tip: For best results when loading legal-size paper, fold in the paper-tray extender before loading the paper to avoid a paper jam.

12

hp psc 1310 series