setup guide
hp photosmart
140 series
1 unpack your printer | 2 plug in the power cord |
|
| Place the printer at least 10 inches (250 mm) |
|
| away from any obstruction to allow space for the |
|
| paper to move through the printer during printing. |
|
| 1. Connect the power cord to the back of your |
|
| printer. |
|
| 2. Plug the power cord into a working electrical |
|
| outlet. |
|
| Important: Make sure the power cord does not | Rear paper path |
| block the rear paper path. | |
| HP #57 |
|
3 load an index card
Note: The index card will be used to print a calibration page in step 6.
1.Open the paper tray door.
2.Place an index card from the sample pack on the paper tray and slide the card underneath the output guide.
3.Move the paper width guide to fit close to the left edge of the index card without bending the card.
Paper width guide
Paper tray
Output guide
