4.For the 300X or 500X Ethernet print servers (J3263A or J3265A), verify that the auto-negotiation switches are in their default positions—all down. (For other options, see page 1-9.)

Figure 2.2 Hardware connections using a U.S. power module for the

 

HP JetDirect J3265A Print Server

 

 

In the following steps, the circled numbers

Note

 

 

 

correspond to those in Figure 2.2. The HP JetDirect

 

 

300X, 170X, and EX Plus have one printer port ➌.

 

 

The HP JetDirect 500X Token Ring and 300X have

 

 

no BNC port ➊. On the HP JetDirect 500X and

 

 

300X, the RJ-45 connector ➋ is used for either 10 or

 

 

100 Mbps operation. The JetDirect 170X has no

 

 

BNC port ➊.

 

 

 

5.Connect the print server to the network ➊ or ➋.

6.Connect the print server to the printer(s) ➌, ➍, and ➎.

If you are attaching only one printer to the 500X, HP recommends that you attach that printer to Port 1 ➌.

If you are using DLC/LLC network protocols, your printer must be connected to Port 1 (the DLC/LLC protocol is supported only on Port 1).

7.Plug the power module into the power receptacle in the back of the print server ➏.

2-2 Hardware Installation