•Press the beard length selector (8) (e) and slide it up in order to set the desired beard length (length settings from top to bottom 1.2 mm, 2.8 mm, 4.4 mm, 6 mm). Push up the styler (4).

•Activate the on/off switch and trim against hair growth by guiding the transparent comb part over the skin.

•The short beard attachment (10) is perfectly suited for creating a stubble look and maintaining it. Attach the short beard attachment the same way as the trimming attachment (7). Push up the styler and use the appliance as shown (f). The short beard attachment ensures an optimum usage angle.

Cleaning

This appliance is suitable for cleaning under an open water tap. Warning: Detach the hand-held part from

the power supply before cleaning it in water. Regular cleaning ensures better shaving performance. Rinsing the shaving head after each shave under running water is an easy and fast way to keep it clean:

•Switch the shaver on (cordless) and rinse the shaving head under hot running water (g). A natural based soap may also be used provided it contains no particles or abrasive substances. Rinse off all foam and let the shaver run for a few more seconds.

•Next, switch off the shaver, remove the shaver foil and the cutter block. Then leave the disassembled shaving parts to dry.

•If you regularly clean the shaver under water, then once a week apply a drop of light machine oil onto the long hair trimmer and shaver foil (i).

Alternatively, you may clean the shaver using the brush provided (h):

•Switch off the shaver. Remove the shaver foil.

•Using the brush, clean the cutter block and the inner area of the shaver head. However, do not clean the shaver foil with the brush as this may damage the foil.

Keeping your shaver in top shapeReplacing the shaving parts

To maintain 100% shaving performance, replace your foil and cutter block at least every 18 months or when worn. Change both parts at the same time for a closer shave with less skin irritation.

(Shaver foil and cutter block: 2000 series)

12