13.Connect external cables to the installed card, if needed. Connect internal cables to the system board, if needed.

14.Replace the access panel.

15.Reconnect the power cord and turn on the computer.

16.Lock any security devices that were disengaged when the access panel was removed.

17.Reconfigure the computer, if necessary. Refer to the Computer Setup (F10) Utility Guide for instructions on using Computer Setup.

Drive Positions

Figure 2-16Drive Positions

Table 2-3Drive Positions

1Two 5.25-inch external drive bays for optional drives (optical drives shown)

2One 3.5-inch external drive bay for optional drive (media card reader shown)

3Secondary 3.5-inch internal hard drive bay for optional hard drive

4Primary 3.5-inch internal hard drive bay

The drive configuration on your computer may be different than the drive configuration in the illustration above.

To verify the type, size, and capacity of the storage devices installed in the computer, run Computer Setup. Refer to the Computer Setup (F10) Utility Guide for more information.

ENWW

Drive Positions 21