load originals and load paper

to load the paper tray

1Remove (pull out) the output tray and slide the paper-width and paper- length guides to their outermost positions.

2Tap the stack on a flat surface to align the edges of the paper, and then check the paper for the following:

–Make sure it is free of rips, dust, wrinkles, and curled or bent edges.

–Make sure all the paper in the stack is the same size and type, unless you are working with photo paper.

3Insert paper into the input tray print-side down until it stops. If you are using letterhead, insert the top of the page first.

Check that the stack of paper contains several sheets but is no higher than the top of the paper-length guide.

4Slide the paper-width and paper-length guides in until they stop at the edges of the paper. Make sure that the paper stack lies flat in the input tray and fits under the tab of the paper-length guide.

reference guide

11