M2 | Speaker always on |
M3 | Speaker off during dialing, on until carrier detected |
O0 | Speaker online to data mode |
O1 | Issue a retrain before returning to Data Mode |
P | Pulse dial |
Q0 | Result codes enabled |
Q1 | Result codes disabled |
T | Tone dial |
V0 | Display results codes as digits |
V1 | Display result codes as text |
Y0 | Disable long space disconnect |
Z0 | Reset & recall user profile 0 |
Z1 | Reset & recall user profile 1 |
&F | Load factory default configuration |
&M0 | Asynchronous mode operation |
&S0 | DSR always ON |
&S1 | DSR comes on when establishing a connection |
| and goes off when the connection ends |
&V | View active profile |
&W0 | Store active profile as Profile 0 |
&Y0 | Select profile 0 upon Power on or reset |
&Zn=x | Store phone number x in into |
| |
\N0 | Buffer mode, no error control |
\N1 | Direct mode |
\N2 | MNP reliable mode |
\N3 | V.42, MNP, or buffer mode (autoreliable mode) |
\N4 | V.42 mode or disconnect |
\Q0 | Disable flow control |
\Q1 | XON/XOFF software flow control |
\Q3 | RTS/CTS hardware flow control |
\Tn | Inactivity timer, |
\V0 | Disable protocol result code appended to DCE |
| speed |
\V1 | Enable protocol result code appended to DCE |
| speed |
Section Four - Support and Service
NOTE: If after trying the recommended troubleshooting tips, you are unable to isolate or resolve a problem, you should consult your computer dealer.
Section Five - Technical Specifications
Modulation Std.: | V.90, K56flex, V.42bis, V.42, V.34, V.32bis, V.32, V.29, |
| V.27ter, V.22bis,V.22, V.21, V.17, Bell212/103 |
Temperature: | 0 to 55 degrees C, operating; |
| operating |
Compression: | MNP 5, 4, 3, 2 |
Host Interface: | PCI Bus socket, PCI spec version 2.1 |
COM ports: | 1, 2, 3, 4, 5 |
IRQ lines: | 3, 4, 5, 7, 9, 10, 11, 12 |
FAX Group: | Group III |
FAX Command: | Class 1 |
