auto-tftp

OVERVIEW

Category:

File Transfer

Primary context:

config

 

 

Related Commands

the section called “client” (page 685)

 

 

Usage: [no] auto-tftp [<IPV4-ADDR IPV6-ADDR> <FILENAME-STR>]

Description: Enable/disable automatic software image download via TFTP during boot. The software image will be downloaded if it has a different version from the software running on the switch. The command requires the parameters to be specified when used without 'no'.

o IPV4-ADDR - specifies the TFTP server IPv4 address to download a software image from.

o IPV6-ADDR - specifies the TFTP server IPv6 address to download a software image from.

o FILENAME-STR - specifies the file-name to download.

COMMAND STRUCTURE

■auto-tftp server-ip-- IPv4 address of the TFTP server to download a software image from. (IP-ADDR)

(p. 70)

■filename -- The software image file-name. (ASCII-STR) (p. 70)

■auto-tftp server-ipv6-- IPv6 address of the TFTP server to download a software image from. (IPV6-ADDR) (p. 71)

■filename -- The software image file-name. (ASCII-STR) (p. 70)

EXAMPLES

Example: auto-tftp IP-ADDR FILENAME

Set the device to boot using image2 located on TFTP server 10.10.2.40, if the image version is different from the one already on the switch:

ProCurve(config)# auto-tftp 10.10.2.40 image2

COMMAND DETAILS

filename (p. 70)

server-ip (p. 70)

server-ipv6 (p. 71)

filename

■auto-tftpIP-ADDR FILENAME

The software image file-name.

■auto-tftpIPV6-ADDR FILENAME

The software image file-name.

server-ip

■auto-tftp IP-ADDR

© 2009 Hewlett-Packard Development Company, L.P.

70