| | | connection-rate-filter |
OVERVIEW | | |
| | |
| Category: | Troubleshooting |
| | |
| Primary context: | config |
| | |
| Related Commands | filter (page 185) |
| | | ip (page 290) |
| | | vlan (page 706) |
| | | show (page 511) |
| | |
| Usage: | connection-rate-filter unblock < host SRC-IP-ADDR SRC-IP-ADDRESS/MASK > |
| | [no] connection-rate-filter sensitivity <lowmediumhighaggressive> |
Description: Re-enables access to a host or set of hosts that has been previously blocked by the connection rate filter. Disabling or setting sensitivity may have improved performance after rebooting the switch
COMMAND STRUCTURE
■connection-rate-filter sensitivity -- Sets the level of filtering required (p. 91)
■sensitive < low medium high ... > --(p. 90)
■connection-rate-filter unblock -- Resets a host previously blocked by the connection rate filter (p. 91)
■all -- Resets all previously blocked by the connection rate filter (p. 90)
■host -- Match packets from the specified IP address. (IP-ADDR) (p. 90)
■src-ip-- Match packets from the specified subnet. (IP-ADDR/MASK-LENGTH) (p. 91)
COMMAND DETAILS
all
■connection-rate-filter unblock all
Resets all previously blocked by the connection rate filter
host
■connection-rate-filter unblock host IP-ADDR
Match packets from the specified IP address.
sensitive
■connection-rate-filter sensitivity < low medium high ... > Supported Values:
■low -- Sets the level of connection rate filtering to low (most permissive)
■medium -- Sets the level of connection rate filtering to medium (permissive)
■high -- Sets the level of connection rate filtering to high (restrictive)
■aggressive -- Sets the level of connection rate filtering to aggressive (most restrictive)
© 2009 Hewlett-Packard Development Company, L.P. | 90 |