console
OVERVIEW
Usage: console ...
Description: Set various console parameters. Use 'console ?' to get a list of all configurable parameters.
The non-configurable parameters and their default values are: Data bits = 8; Parity = None; Stop bits = 1.
COMMAND STRUCTURE
■console baud-rate< speed-sense 1200 2400 ... > -- Set the data transmission speed for the device connect sessions initiated through the Console port (p. 93)
■console events < None Debug All ... > -- Set level of the events displayed in the device's Events Log (p. 93)
■console flow-control< XON/XOFF None > -- Set the Flow Control Method; default is xon-xoff
(p. 93)
■console inactivity-timer< 0 1 5 ... > -- Set the number of minutes of no activity detected on the Console port before the switch terminates a communication session (p. 94)
■console local-terminal< VT100 NONE ANSI > -- Set type of terminal being used for the current console or telnet session (default is vt100) (p. 94)
■console screen-refresh< 1 3 5 ... > -- Set default number of seconds before screen is refreshed on the repeat command (p. 94)
■console terminal < VT100 NONE ANSI > -- Set type of terminal being used for all console and telnet sessions (default is vt100) (p. 95)
EXAMPLES
Example: console <...>
Configure the switch to use the following console settings:
■VT100 operation
■19,200 baud
■No flow control
■10-minute inactivity time
■Critical log events
ProCurve(config)# console terminal vt100 baud-rate 19200 flow-control none inactivity-timer 10 events
critical
Command will take effect after saving configuration and reboot.
© 2009 Hewlett-Packard Development Company, L.P. | 92 |