Modem module cable
NOTE: The modem module cable is included in the Cable Kit, spare part number
Before removing the modem module cable, follow these steps:
1.Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the computer on, and then shut it down through the operating system.
2.Disconnect all external devices connected to the computer.
3.Disconnect the power from the computer by first unplugging the power cord from the AC outlet and then unplugging the AC adapter from the computer.
4.Remove the battery (see Battery on page 45).
5.Remove the service access cover (see Service access cover on page 46).
6.Remove the optical drive (see Optical drive on page 58) or upgrade bay hard drive (see Upgrade bay hard drive on page 60).
7.Remove the keyboard (see Keyboard on page 65).
8.Remove the top cover (see Top cover on page 81).
9.Remove the Smart Card reader (see Smart Card reader on page 51).
10.Remove the Audio/USB 2.0 board (see Audio/USB 2.0 board on page 96).
11.Remove the modem module (see Modem module on page 99).
Remove the modem module cable:
1.Position the computer right
2.Remove the modem cable (1) from the routing clips in the base enclosure.
3.Loosen the Torx M2.0x3.0 screw (2).
Component replacement procedures 101