CAUTION:
THE ABOVE CHART IS ONLY A REFERENCE FOR WIRE SIZING. DO NOT USE THIS INFORMATION TO ACTUALLY SIZE THE WIRE TO YOUR POWER DRIVE. YOU MUST CONSULT A LICENSED ELECTRICAL CONTRACTOR WHO WILL DETERMINE THE ACTUAL WIRE SIZE REQUIRED TO SUIT YOUR PARTICULAR APPLICATION.
2.Use plastic zip ties and any other supplies needed to tie off the electrical cords. This protects the cords from abrasion, sharp objects, water contact and other harm.
WIRING PROCEDURES
Salzer Reversing Switch - 110VAC ( 3/4 HP Motors)
INCOMING POWER | to SALZER SWITCH | to MOTOR FEED | to MOTOR JUNC. BOX | |
BLACK | 3 | (3,7,11 jumpered) | na | na |
WHITE | 1 | (1,5,9 jumpered) | na | na |
GREEN |
| GROUND BAR | GREEN / BARE | GROUND |
|
| 2 | YELLOW or WHITE | T1 & T3 |
|
| 4 | ORANGE | T2 & T4 |
| 8 | (6,8 jumpered) | BLACK | T8 |
| 12 | (10,12 jumpered) | RED | T5 |
Note: To reverse motor direction operation, reverse wiring of Black (T8) & Red (T5) at motor junction box.
For motors greater than 3/4 hp, a higher rated switch must be used. Contact RGC for additional information.
Remote Control - 110 VAC (3/4 HP Motors)
RC MOTOR FEED | to MOTOR JUNC. BOX |
GREEN / BARE | GROUND |
YELLOW or WHITE | T1 & T3 |
ORANGE | T2 & T4 |
BLACK | T8 |
RED | T5 |
Note: To reverse motor direction operation, reverse wiring of Black (T8) & Red (T5) at motor junction box.
Motor Specifications
RGC PN: | 6500684 |
HP: | 3/4 |
RPM: | 1725 |
VOLTAGE: | 115 / |
AMPS: | 8.2 / |