HP BL10e manual Technical Specifications

QuickSpecs

HP ProLiant BL10e Generation 2 (G2) Server Blade

Technical Specifications

HP ProLiant BL10e G2	Dimensions	Height	5.25 in (13.35 cm) (3U)
Server Blade Enclosure		Width	17.5 in (44.45 cm)
		Depth	28.35 in (72.01 cm)
	Weight	Interconnect Tray	4.5 lb (2.04 kg)
		20 server blades	35 lb (15.86 kg)
		Enclosure with 2 power supplies	54.5 lb (24.7 kg)
		Total weight fully loaded	94 lb (41.73 kg)
Power Supply	600W, Hot-Plug	Two Redundant Power Supplies (optimized to provide full redundancy at 120 and 220
	Redundant	volts)
	(2 standard)
	Input Specifications	Normal Line Voltage	100 to 127VAC, 200 to 240VAC
		Range Input Line	90 to 264VAC
		Frequency Range	43 to 63Hz
		Power Factor	> 0.95 (120Vac/Max Load)
		Input Current	8.5A @ 120VAC, 4.3A @ 240VAC
		Inrush Current	25A
		Holdup Time	25mS
	General Specifications	Full Output Rating	600W
		Minimum Load
	Dielectric Voltage	Input to Output	1500Vac or 2150Vdc (1 Min.)
	Withstand	Input to Ground	1500Vac or 2150Vdc (1 Min.)
	Input Transient	Common and Differential	2200V
	Susceptibility	Mode (superimposed on AC
		line)
		Differential Mode	1100V
	NOTES: ProLiant BL e-Class Power Calculator is available from the product page at the following address:
	http://www.Compaq.com/products/servers/proliant-bl/e-class/index.html
	Click "Power Calculator" in the "Support" section.
Non-Hot Plug Ultra	40 GB 5.4 K	Capacity	40,007 MB
ATA/100 Hard Drives		Height	0.374 in (9.5 mm)
		Width	2.756 in (70 mm)
		Interface	Ultra ATA-5 (IDE) 100 MB/s
		Transfer Rate Synchronous	27.8 to 44.1 MB/sec (Disk-Buffer)
		(Maximum)
		Seek Time	Single Track	13 ms
		(typical reads, including
		settling)
			Rotational Speed	5,400 RPM
		Physical Configuration	Bytes/Sector	512
			Logical Blocks	78,140,160 (LBA)

DA - 11686 Worldwide — Version 13 — October 8, 2004 Page 21