13.Connect external cables to the installed card, if needed. Connect internal cables to the system board, if needed.
14.Replace the computer access panel.
15.Reconnect the power cord and any external devices, then turn on the computer.
16.Lock any security devices that were disengaged when the access panel was removed.
17.Reconfigure the computer, if necessary. Refer to the Computer Setup (F10) Utility Guide for instructions on using Computer Setup.
Drive Positions
Figure
Table
1Two
2One
3Primary
4Secondary
To verify the type, size, and capacity of the storage devices installed in the computer, run Computer Setup. Refer to the Computer Setup (F10) Utility Guide for more information.
22 Chapter 2 Hardware Upgrades | ENWW |