HP DJm-909 CHECKING ACCESSORIES, CONNECTIONS, 1. Connecting Input Components, MIC, SESSION IN, DJ CD Players, Analog turntable / Cassette deck, etc

CHECKING ACCESSORIES

÷ Hexagonal Allen driver	÷	These operating instructions
(for cross fader operating load adjust screw)	÷	Warranty

CONNECTIONS

When connecting or changing the connection of units, make sure to first turn off the power switch and disconnect the power cord from the outlet.

This mixer is not furnished with any connection cables; when performing connections, use the cables that came provided with your player and other components, or purchase commercially available audio cables.

1. Connecting Input Components

	[DJ CD Player]
Analog turntable 2	CDJ-800, CDJ-1000, CDJ-1000MK2,		Analog turntable 1
	CDJ-100S, CDJ-700S, CDJ-500II,
	CMX-3000, CMX-5000, DMP-555
	Player B	Player A
Cassette deck, etc.			Cassette deck, etc.
2	1	1	2
			Microphone
R	L	R L R L

			CONTRAST			BRIGHT
	CH-2	L	SEND	L	RETURN		CH-1	MIC
	R		R		R	L	R	L
L		CD					CD
	MASTER 2
R		PHONO	(MONO)			(MONO)	PHONO
	L
R		/ LINE		MASTER 1			/ LINE
								R	L
		PHONO			3 COLD			PHONO
					1 GND
	SIGNAL	LINE					SIGNAL	LINE	SESSION IN
	GND	CH-2 PLAYER					GND
	BOOTH/			R	2 HOT	L	CH-1 PLAYER
		CONTROL					CONTROL
	SESSION OUT

3

L

R

4

CH-2 PHONO/LINE	CH-1 PHONO/LINE	Other mixer output
selector switch	selector switch

DJ CD Players 1

Connect the AUDIO OUT connectors from Player A to the CH-1 CD input jacks of the DJ mixer, and connect the AUDIO OUT connectors from Player B to the CH-2 CD input jacks.

When using one of the listed DJ CD players, the control cord furnished with the CD player should be connected between the player and the DJ mixer. In this way, the DJ mixer’s fader lever can be operated to control operation of the DJ CD player for fader start play and back cue.

Connect the analog turntable 2 output cables to the CH-2 PHONO/LINE jacks of the DJ mixer, and connect the ground wire to the SIGNAL GND terminal. Set the CH-2 PHONO/ LINE selector switch to [PHONO]. When connecting a cassette deck or other such component to these jacks, set the CH-2 PHONO/LINE selector switch to [LINE].

*The PHONO input for this DJ mixer supports use of a MM cartridge.

Analog turntable / Cassette deck, etc. 2

Connect the analog turntable 1 output cables to the CH-1 PHONO/LINE jacks of the DJ mixer, and connect the ground wire to the SIGNAL GND terminal. Set the CH-1 PHONO/ LINE selector switch to [PHONO]. When connecting a cassette deck or other such component to these jacks, set the CH-1 PHONO/LINE selector switch to [LINE].

MIC 3

The MIC jack on this unit supports use of either PHONE type or XLR type plugs.

SESSION IN 4

When using multiple mixers simultaneously, use the appropriate audio cables to connect the other mixer outputs

to these jacks. 5

<DRB1349>