Removing a 3.5" Media Card Reader or Diskette Drive
The 3.5" external drive bay may be populated with a diskette drive or a media card reader. The removal procedure is the same for both devices.
1.Remove/disengage any security devices that prohibit opening the computer.
2.Remove all removable media, such as diskettes or compact discs, from the computer.
3.Turn off the computer properly through the operating system, then turn off any external devices.
4.Disconnect the power cord from the power outlet and the computer, and disconnect any external devices.
WARNING! When the computer is plugged into an AC power source, voltage is always applied to the system board. To reduce the risk of personal injury from electrical shock and/or hot surfaces, be sure to disconnect the power cord from the wall outlet and allow the internal system components to cool before touching.
5.Remove the access panel and front bezel. Refer to Removing the Computer Access Panel and Front Bezel on page 5.
6.If the device is a media card reader, disconnect the internal USB cable from the system board. If the device is a diskette drive, disconnect the power and data cables from the back of the drive.
7.Remove the two retainer screws that secure the drive to the bay (1) then slide the drive forward and out of the bay (2).
Figure
To install a drive, reverse the removal procedure. Refer to the following table for proper retainer and guide screw locations.
Device | Retainer Screws | Guide Screws |
|
|
|
Diskette Drive | 2 (labeled “FDD” on chassis) | 1 (front left side of drive) |
|
|
|
Media Card Reader | 2 (labeled “CR” on chassis) | none |
|
|
|
16 Chapter 2 Hardware Upgrades | ENWW |