To Manually Conﬁgure the Interface Pod | HP E5123A specs

To Set Up the Interface Pod

To Manually Conﬁgure the Interface Pod

1From the Configure menu, select the appropriate port; then select Set Up.

2Click the STM-1 tab.

3Select the parameters you require.

4Click to set the configuration

or

Click Auto to set the parameters to the default settings. A message warns you that the reconfiguration will cause some measurements and data to be lost and asks if you want to continue. Click OK.

Note When the configuration is complete, the analyzer updates all relevant screens and windows to reflect the new configuration parameters.

9

Image 13

HP E5123A manual To Manually Conﬁgure the Interface Pod, Click the STM-1 tab

Contents

Broadband Service Analyzer Setting Up STM-1 Electrical Interface Pod Copyright WarrantyPrinting history Product support Contents What is it? What does it do? About the STM-1 Electrical Interface Pod Online Help To Access User Online HelpOnline Help Front Panel at a Glance Access Signal OutFront Panel at a Glance To Set Up the Interface Pod To Set Up the Interface Pod To Insert the Interface Pod To Connect to the System Under Test To Remove the Interface Pod Receive Rx See also Automatic Conﬁguration Parameters Click the STM-1 tab To Manually Conﬁgure the Interface Pod What to Do Next What to Do Next Standards and Speciﬁcations Standards and SpecificationsCommunications Standards Input and Output Speciﬁcations Physical Speciﬁcations Error Generation SpeciﬁcationsEnvironmental Speciﬁcations Certification Limitation of WarrantyExclusive Remedies Restricted Rights Legend Safety Symbols Do not clean with fluidsKeep away from live Service non autorisé Service et ajustementSymboles des sécurité Avertissement Declaration of Conformity Page