E
Product Notes for Hewlett-Packard
This appendix describes how to include the tape drive SBB in an HP 9000 Series 700 system running HP-UX
9.05(or later) and Series 800 system running HP-UX 9.04 (or later). The information covers configuration of the host system to communicate with the tape drive.
E.1 General Information
If the necessary drivers are not already built into your existing kernel, you will need to rebuild your kernel.
When using the dump utility under HP-UX, you must supply the correct density code and tape length size for dump to use in its calculations. Refer to Section E.2.2 for details. We recommend a value of 126 for the blocking factor parameter.
Compression can be enabled/disabled at any time by selecting the appropriate device file name. See Section E.2.1.3 and E.2.1.4 for device names.
E.2 Modifications Required for HP-UX 9.05 on Series 700 Systems and HP-UX 9.04 on Series 800 Systems
E.2.1 Installation Procedure
NOTES
The "EXB-85058SQANXR1" designation returned in response to SCSI inquiry during performance of the following procedure is the StorageWorks internal name for the tape drive, as incorporated in and used by the firmware.
E.2.1.1 Installation of Tape Drive
After ensuring that the address of the tape drive does not conflict with the address of any other device on that SCSI bus, install the tape drive into the StorageWorks enclosure and power-on the workstation.
E.2.1.2 System Modification
Enter the System Administration Manager (SAM) as superuser. From the first-level menu, choose Peripheral Devices. From the second-level menu, choose Tape Drives. The system’s hardware will be scanned, and the available tape drives window will identify the tape drive SBB as a SCSI tape drive with the appropriate hardware path. Highlight that selection and then pull down the Actions menu and select the Add function. The program at
Order Number: EK–STWCT–UG. E01 | E–1 |