Solve paper feed or jam problems

If the product has recurring problems with paper feeding or with jams, use the following information to reduce the number of occurrences.

The product does not pick up paper

If the product does not pick up paper from the tray, try these solutions.

1.Open the product and remove any jammed sheets of paper.

2.Load the tray with the correct size of paper for your job.

3.Make sure the paper size and type are set correctly on the product control panel.

4.Make sure the paper guides in the tray are adjusted correctly for the size of paper. Adjust the guides to the appropriate indentation in the tray.

5.Check the product control panel to see if the product is waiting for you to acknowledge a prompt to feed the paper manually. Load paper, and continue.

6.The rollers above the tray might be contaminated. Clean the rollers with a lint-free cloth dampened with warm water.

The product picks up multiple sheets of paper

If the product picks up multiple sheets of paper from the tray, try these solutions.

1.Remove the stack of paper from the tray and flex it, rotate it 180 degrees, and flip it over. Do not fan the paper. Return the stack of paper to the tray.

2.Use only paper that meets HP specifications for this product.

3.Use paper that is not wrinkled, folded, or damaged. If necessary, use paper from a different package.

4.Make sure the tray is not overfilled. If it is, remove the entire stack of paper from the tray, straighten the stack, and then return some of the paper to the tray.

5.Make sure the paper guides in the tray are adjusted correctly for the size of paper. Adjust the guides to the appropriate indentation in the tray.

6.Make sure the printing environment is within recommended specifications.

Frequent or recurring paper jams

Follow these steps to solve problems with frequent paper jams. If the first step does not resolve the problem continue with the next step until you have resolved the problem.

1.If paper has jammed in the product, clear the jam and then print a configuration page to test the product.

2.Check that the tray is configured for the correct paper size and type on the product control panel. Adjust paper settings if necessary.

3.Turn the product off, wait 30 seconds, and then turn it on again.

4.Print a cleaning page to remove excess toner from inside the product.

74 Chapter 8 Solve problems

ENWW