User’s Guide
INTRODUCTION
Warning
TO PREVENT SHOCK, DO NOT OPEN THE CABINET. NO USER
Safety Instructions
1.Read this user’s guide before you operate your projector and save it for future reference.
2.The lamp becomes extremely hot during operation. Allow the projector to cool for approximately 45 minutes prior to removing the lamp assembly for replacement. Do not operate lamps beyond the rated lamp life. Excessive operation of lamps beyond the rated life could cause them to explode on rare occasions.
3.Never replace the lamp assembly or any electronic components unless the projector is unplugged.
4.To reduce the risk of electric shock, do not disassemble this appliance. Take it to a qualified technician when service or repair is required. Incorrect reassembly can cause electric shock when the appliance is subsequently used.
5.Do not place this product on an unstable cart, stand, or table. The product may fall, sustaining serious damage.
6.This product is capable of displaying inverted images for ceiling mount installation. Please use suitable equipment for mounting the unit and ensure it is securely installed.
Caution
•Always remove the lens cap when the projector lamp is on.•Do not look straight at the projector lens during operation. The intense light beam may damage your eyes.
•In some countries, the line voltage is NOT stable. This projector is designed to operate safely within a bandwidth of 110 to 230 volts, but could fail if power cuts or surges of more than10 volts occur. In these
Save this user’s guide: The information contained in this manual will assist you in operating and maintaining your personal projector.
Introduction 5