10. Regulation Statements
Safety information
Safety Precautions
•Prevent eye injury. Do not look into the projector's lens when the lamp is on. Do not point any laser light at anyone's eyes.
•Prevent electrical shock. Do not expose the projector or rain or moisture. Do not open the projector except as instructed by the manual.
•Allow the projector to cool before removing the lamp cover and touching internal components, as instructed by the manual.
•Keep paper, plastic, and combustible material at least 0.5 meter (2 feet) away from the projector lens and exhaust vents.
•Use only an approved power cord rated for the voltage and current marked on the product label. Do not overload any outlet or extension cord.
Mercury Safety
Warning: This digital projector lamp contains a small amount of mercury. If the lamp breaks, adequately ventilate the area where the breakage occurred. Disposal of this lamp may be regulated due to environmental considerations. For disposal or recycling information, please contact your local authorities or the Electronic Indus- tries Alliance (www.eiae.org).
Regulatory information
This section presents information that shows how your digital projector complies with regulations in certain regions. Any modifications to your digital projector not expressly approved by
U.S.A.
This digital projector has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installa- tion.
This digital projector generates, uses, and can radiate radio frequency energy. If not installed and used in accordance with the instructions, it may cause harmful inter- ference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this digital projector does cause harmful interference to radio or television reception (which can be determined by unplug- ging the unit), try the following:
•Reorienting or relocating the receiving antenna.
•Relocating the digital projector with respect to the receiver.
•Connecting the digital projector's power cord to another power outlet.
Connections to Peripheral Devices. To maintain compliance with FCC Rules and Regulations, use properly shielded cables with this device.
10. Regulation Statements | 39 |
