2 Setting Up the Monitor

To set up the monitor, ensure that the power is turned off to the monitor, computer system, and other attached devices, then follow the instructions below.

NOTE: Be sure the master power switch, located on the rear panel of the monitor, is in the off position. The master power switch turns off all power to the monitor.

Installing the Pedestal

NOTE: Do not install the pedestal if the monitor will be used on a wall, swing arm, or other mounting fixture; instead see Mounting the Monitor to User-Supplied Support Hardware on page 14 in this chapter.

CAUTION: Whenever you handle the monitor, take care not to touch the surface of the LCD panel. Pressure on the panel may cause non-uniformity of color or disorientation of the liquid crystals. If this occurs the screen will not recover to its normal condition.

To assemble the ZR2040w, slide the pedestal upright into its base, as shown on the following page.

Figure 2-1Assembling the ZR2040w pedestal

Installing the Pedestal

5