Paper shredder | HSM 225.2 |
|
|
7. Troubleshooting Paper jam
You have fed in too much paper.
• Red LED on control panel lights.
•The cutting device runs in reverse for approx. 2 seconds automati- cally.
•Paper is pushed out.
Caution!
1 Do not press rocker switch alter-
2nately forwards/backwards (pos. 1
/ pos. 2):
Cutting unit can be damaged.
•Devices with strip cut
If the paper is too low and cannot
be taken out:
Activate the rocker switch -
2pos. 2 several times briefly.
•Devices with particle cut
Pull out the paper from the paper feed opening. Light barrier must be free of obstacles.
•Separate paper stack.
1• Press rocker switch pos. 1.
• Feed paper successively.
Door contact interrupted
• Red LED on control panel lights.
•Paper shredder switches off.
•Check whether front door is closed properly.
If other faults occur, please check the follo- wing before calling our customer service:
•Is mains plug inserted?
•Is rocker switch turned on?
•Is the motor overloaded?
allow motor to cool down for 15 - 20 min.
8. Maintenance and care
Cleaning:
•Switch off the shredder, pull out the mains plug.
•When cleaning only use a soft cloth and a mild
Cut material container full
When the cutting capacity drops or
2
• Red LED on control panel lights.
•Paper shredder switches off Empty the cut material container, because if it is too full, malfunc- tions can occur in the cutting sys- tem
• Tap rocker switch pos. 2.
• Remove full shredded material
bag and insert new bag.
the noise increases (Cross cut):
• Switch paper shredder off: Tap rocker switch pos. 2.
2
| • Spray special cutting block oil th- |
| rough paper feed opening across |
| the whole width of the cutting |
| system blades. |
| • Run cutting system backwards |
2 | (pos. 2) without feeding paper. |
• Paper dust and particles are shaken off.
0510 | english | 9 |