Congratulations
You have just purchased an HTC
General Safety Instructions for Power Tools
1.Know your power tool. Read and understand the Owner’s Manual and observe the warnings and instruction labels affixed to the tool.
2.Properly ground all tools.
3.Keep guards in place.
4.Remove adjusting keys and wrenches.
5.Keep work area clean and dry.
6.Keep children away.
7.Never leave running machines/tools unattended.
8.Disconnect tools from service.
9.Regularly maintain tools.
10.Use correct tools for the job.
11.Never force a tool.
12.Wear safety apparel.
13.Wear safety glasses/goggles.
14.Never stand or sit on tools.
15.Replace damaged components immediately.
16.Think Safety. Safety is a combination of operator awareness, common sense and alertness at all times.
Safety Instructions for Drill Press Support
1.Be thoroughly acquainted with all safety and operational instructions regarding your drill press in this manual and those from the machine manufacturer.
2.Keep extensions within safe operating limits.
3.Line up support rollers with drill press table surface before use.
4.Use additional support(s) if workpiece exceeds the weight limits of this unit or makes the drill press unstable or when working with long pieces.
5.Test the
Assembly Instructions
Tools needed: (2)1/2” wrenches,
1.Unpack and make certain all parts and hardware are included and are not damaged from shipment.
2.Install Column Clamps and as shown. This is the only step you’ll need the wrenches. Use (2) long 5/16” – 18 bolts , (1) Lock Nut and the Large Threaded Hand Knob . Adjust Clamp Bolts / Nuts so that the Clamp Bolts are equally spaced.
3.For starters, adjust the Clamp to be 5” to 6” (12.5cm to 15cm) below the drill press table.
