4.Thread the (5) Lock Knobs into their respective threaded holes.
5.Slip the Central Support/Drill Tray Assembly into the adapter tube of the Column Clamp and tighten the Locking Knob.
6.Slip the Extensions into the Central Support Assembly and tighten with Lock Knobs.
7.Slide the Roller Support Brackets into the vertical sockets of the Extensions and tighten with Lock Knobs.
8.Install Rollers into the Roller Support Brackets by inserting the fixed end of the roller axle into the roller axle hole and then depress (with a screwdriver or putty knife) the other end of the axle and slip it into place until the end of the axle pops into the hole.
9.Adjust the height of the Roller Bracket so the top of the rollers are even with the drill press table. Move extensions in and out as desired to support your workpiece. To save space and reduce obstructions in your shop, keep supports pushed in as far as possible when not in use.
CAUTION: Observe all safety instructions and warnings regarding the safe use of this accessory support and your drill press.
Parts List
| Qty | Description | Part No. |
1 | Column Clamp Strap | 2616 | |
1 | Column Clamp/Adapter | 2617 | |
1 | Central Support/Drill Tray | 2618 | |
2 | Extension | 2792 | |
2 | Roller Support Bracket - T | 2621 | |
2 | 10" Roller | 2031 | |
1 | Column Anchor Bolts | C307 | |
1 | Locking Nut | C201 | |
1 | Threaded Knob | 2622 | |
5 | Lock Knob | G101 | |
|
|
|
|