User Manual - Configuration Guide (Volume 3)

Chapter 2

Versatile Routing Platform

IP Fax Configuration

 

Table VC-2-9Monitoring and maintenance of IP Fax

 

 

 

 

 

Operation

Command

 

 

 

 

Open all of the debugging information switches of ipfax

debug ipfax all

 

Open the debugging information switch of function api of ipfax

debug ipfax api

 

Open the debugging information switch of main task of ipfax

debug ipfax cc

 

Open the debugging information switch of controller of ipfax

debug ipfax controller

 

Open the debugging information switch of level 1 error message of ipfax

debug ipfax error 1_level

 

Open the debugging information switch of level 2 error message of ipfax

debug ipfax error 2_level

 

Open the debugging information switch of level 3 error message of ipfax

debug ipfax error 3_level

 

Open the debugging information switch of all levels of error messages of

debug ipfax error all

 

ipfax

 

 

Open the debugging information switch of T38 message of ipfax

debug ipfax t38

 

Open the debugging information switch of cisco message of ipfax

debug ipfax cisco

 

Open the debugging information switch for reading and writing fax data

debug vpm fax

 

between vpm module and voice card.

 

2.4 Typical Configuration of IP Fax

The networking mode of IP Fax is basically the same as IP Phone. Thus, the functions of IP Fax can be realized only when the telephone sets in the network of IP Phone are replaced by facsimile machines. You can basically use the functions of IP Fax only if you can configure IP Phone. The operation is easy to use.

1)Networking Requirements

Suppose a company headquarter located in Shenzhen plans to send/receive faxes to/from its Beijing branch via IP network.

The fax number of its Beijing branch is 0101002, and the number of Shenzhen headquarter is 07551001.

The IP address used to access to the Internet port through the router in Beijing is

1.1.1.2.The IP address used to access to the Internet port through the router in Shenzhen is 1.1.1.1.

The facsimile machine in Beijing is connected with the second voice port on the router, and the facsimile machine in Shenzhen is connected with the first voice port on the router.

2)Networking Diagram

port2

1.1.1.2

1.1.1.1

port1

 

 

Internet

 

0101002

Router

Router

07551001

 

Beijing

Shenzhen

 

Figure VC-2-2Networking diagram for typical IP fax configuration

 

3)Configuration Procedure

The parameter settings for the router in Beijing is as follows:

Quidway(config)# dial-peer voice 1 voip

Quidway(config-peer-voip1)# destination 07551001

Quidway(config-peer-voip1)# session target ipv4:1.1.1.1

2-6

Page 12
Image 12
Huawei v200r001 user manual Typical Configuration of IP Fax, Table VC-2-9Monitoring and maintenance of IP Fax