Huawei v200r001 user manual Configuring Gateway Carrier Transmit Energy Level

User Manual - Configuration Guide (Volume 3)	Chapter 2
Versatile Routing Platform	IP Fax Configuration

received “1” is less than the preset threshold value, then the current rate train is successful, otherwise, it is not successful.

Please perform the following configuration in dial peer configuration mode.

Table VC-2-4Configure fax local-train threshold value

Operation	Command
Configure fax local-train threshold value	fax local-train threshold threshold
Restore the default value of fax local-train threshold value	no fax local-train threshold

By default, the fax local-train threshold value is 10. The threshold value ranges from 0 to 100.

2.2.6 Configuring Gateway Carrier Transmit Energy Level

Generally, the default values of gateway carrier transmit energy level are acceptable. If subscriber found fax could not established when the other configurations are correct, you may try to adjust the gateway carrier transmit energy level. Less energy level value shows higher energy.

Please perform the following configuration in dial peer configuration mode.

Table VC-2-5Configure gateway carrier transmit energy level

Operation	Command
Configure gateway carrier transmit energy level	fax level level
Restore the default value of gateway carrier transmit energy level	no fax level

By default, the gateway carrier transmit energy level is 15. The level value ranges from 3 to 60.

2.2.7 Configuring Sending Redundancy Packet Number of T38 Fax Protocol

Low-speed data indicates the command data compliant with V.21 and the data rate is 300bps. High-speed data indicates TCF and image data.

Please perform the following configuration in dial peer configuration mode.

Table VC-2-6Configure sending redundancy packet number of T38 fax protocol

Operation	Command
Configure redundancy packet number of low-speed data of	fax protocol t38 ls-redundancy number
T38 fax protocol
Restore the default value of redundancy packet number of	no fax protocol t38 ls-redundancy
low-speed data of T38 fax protocol
Configure redundancy packet number of high-speed data of	fax protocol t38 hs-redundancy number
T38 fax protocol
Restore the default value of redundancy packet number of	no fax protocol t38 hs-redundancy
high-speed data of T38 fax protocol

2-4