8
Configuring the ISDN gateway

Step one: Log in to the ISDN gateway

All administration of the ISDN gateway is performed via the web interface.
To log in to the ISDN gateway:
1 Log in to the Supervisor’s web interface.
2Go to Hardware > Blades and click the IP address of the ISDN gateway.
3Click
Click here to log in, and then click Change log in and enter the user
name admin with no password.

Step two: Set up the ISDN interfaces

1 In the web interface, go to Settings > ISDN.
2 Select the ISDN interface type to match that of your installation; E1 is typically
used in the UK and mainland Europe, T1 (USA and Canada) in North America,
and T1(Japan) in Japan.
3 Complete the other settings as required by your network, referring to the online
help for further information.
4Click
Apply changes to save any changes you have made to the configuration.
5 Restart the ISDN gateway (this is only necessary if you changed the ISDN
configuration). To do this:
iGo to Settings > Shutdown, and click Shut down ISDN GW.
ii Confirm that you want to shut down the ISDN gateway.
iii Click Restart ISDN GW.
6 When the ISDN gateway has restarted, log in to the web interface again, and go
to Settings > ISDN ports.
7 Complete the settings for ISDN Port 1 as required by your network, referring to
the online help for further information. Note that all ISDN ports on the ISDN
gateway are enabled by default.
8Click
Apply changes to save your configuration changes to the ISDN port.
9 If required, configure another ISDN port by selecting the port number from the
numbered links at the top right of the ISDN port configuration page.
Codian recommends that you change the admin account to use a
password as soon as possible. To do that, go to Users, click the admin
link, and provide the required user information.
i