GENERAL OPERATION
Before closing the switch to allow electric current to flow to the water heater, make certain that the water heater is full of water and that the cold water inlet valve is open. Complete failure of the heating element(s) will result if they are not totally immersed in water at all times. Failure of the element(s) due to
When the switch is closed, the operation of this electric water heater is automatic. The thermostats are preset to the “HOT” setting to provide a water temperature of approximately 120°F (49°C) to reduce the risk of scald injury.
CAUTION
Scalding may occur within five (5) seconds at a temperature setting of 140°F (60°C).
Care must be taken whenever using hot water to avoid scalding injury. Certain appliances require high temperature hot water (such as dishwashers and automatic clothes washers).
TO FILL THE WATER HEATER
1.Close the water heater drain valve (if provided) by inserting a standard flat head screwdriver into the slot and turning clockwise.
2.Open the cold water supply
3.Open several hot water faucets to allow air to escape from the system.
4.When a steady stream of water flows from the faucets, the water heater is filled. Close the faucets and check for water leaks at the water heater drain valve, combination temperature and pressure relief valve and the hot and cold water connections.
TO DRAIN THE WATER HEATER
Should it become necessary to completely drain the water heater, make sure you follow the steps below:
1.Disconnect the power supply to the water heater. Consult the plumbing professional or electric company in your area for service.
2.Close the cold water supply
3.Open the drain valve (if provided) on the water heater by inserting a standard flat head screwdriver into the slot and turning counter- clockwise. The drain valve has threads on the end that will allow connection of a standard hose coupling. For those models not equipped with a drain valve, disconnect cold water inlet piping at a convenient connection location as close to an adequate drain as possible.
CAUTION! THIS WATER MAY BE HOT.
4.Open a hot water faucet to allow air to enter the system.
To refill the water heater, refer to “TO FILL THE WATER HEATER.”
14
