Hubbell Electric Heater Company B manual Heating Element, Disconnect power from unit

HEATING ELEMENT

1.Disconnect power from unit.

2.Shut off incoming water supply.

3.Attach hose to drain connection.

4.Lift manual release lever on relief valve to let air into system or break union on outgoing water line.

5.Drain water from tank.

6.Disconnect the wires from the heating element terminals. Note that picture shown is a three- phase heating element; a single-phase element has only two terminals.

7. Remove the 3/8-16 nuts.	Tank Flange
Element Terminals

Nuts

8. Withdraw element assembly and remove gasket. Gasket

Element Assembly

9.Install new gasket and insert new heating element.

10.Rewire element according to the installation instructions as shown in the Section II.

11.Fill tank and check around gasket for any leaks.

20