Rear Reflector Bracket Installation
This section covers several different placements of the rear reflector bracket. Make sure the rear reflector is vertical (perpendicular to the ground).
The rear reflector bracket will mount on the seat post, post clamp, or rear brace. Some models may already have the brackets and reflectors installed. If the reflector is not installed, refer to the “Rear Reflector Bracket and Red Reflector Assembly” section.
Determine which type of reflector bracket you have and its mounting location and then follow the instructions for that style.
Seat Post | Seat Post | Post Clamp | Rear Brace |
Seat Post
1. Assemble the reflector bracket to the seat post:
NOTE: If the reflector bracket is too large for the seat post, put the rubber spacer inside the clamp.
-Make sure the red reflector [4] is vertical, points toward the rear of the bicycle, and has three inches of clearance between the top of the seat and the top of the red reflector.
-Hold the red reflector in this position and tighten the screw(s).
Post Clamp
1.Put the rear reflector bracket on the post clamp:
-Make sure the rear reflector bracket points up
-Put the bolt through the reflector bracket and the post clamp [8]
-Install nut (or nut and washer)
-Do not tighten at this time.
