BASSBASE 400 - M A N U A L
Red VARIMETRIC LED:
Illuminates to indicate | FX LOOP ON: Press this button | ||
to activate the EBASSBASE 400’s | |||
the VARIMETRIC EQ is | |||
parallel F X loop | |||
active. | |||
|
| ||
VARIMETRIC ON: | Green FX LED: | ||
Activates the |
| Indicates the FX | |
VARIMETRIC EQ. | loop is active. | ||
NOTCH FILTER: This
adjustable, extremely narrow-band filter is not
used for normal sound- shaping, but to suppress specific stage and room resonances (e.g. a stage floor’s sympathetic vibrations).
DYNACLIP LED: Illuminates when the DYNACLIP power | , | ||
amp circuit is active. DYNACLIP eliminates undesirable |
| ||
power amp distortion and provides 20% additional |
| ||
headroom in comparison with conventional power amps. |
| ||
| PROTECT LED: Illuminates when one of the power |
| |
amp circuit breakers has tripped. Inadequate |
| ||
ventilation, a short circuit in the SPEAKER OUTS or |
| ||
direct current in the output will trigger the circuit |
| ||
| breaker. |
| |
|
| TEMP LED: Indicates that thermal overload |
|
|
|
| |
|
| (overheating) is the reason why the protective |
|
|
| circuit has activated (e.g. when the ribbed |
|
|
| ventilation duct is obstructed). |
|
|
|
|
|
|
|
|
|
- MAINS: AC
power switch.
MAINS
FREQ KHZ | LEVEL dB | FREQ HZ | CUT dB |
FREQ: Use this control to adjust the notch filter’s center frequency within a range of 30 to 500 Hz.
LEVEL: T s control adjusts the level of the center frequency you selected via the FREQ KHZ control.
PHONES
MASTER: Controls | I |
|
the BASSBASE 400’s | PHONES: Plug headphones | |
overall output. | with | an impedance rating |
| within the | |
| into | this jack. |
FX- MIX : The FX MIX pot adjusts the balance between the original signal and the processed signal. DRY = original signal only, WET = processed signal only.
FREQ KHZ: Defines the center | CUT: Turn this control up to suppress the |
frequency for the EQ'sHI | frequency you selected via the FREQ |
RANGE section. | control. |
5
