Humminbird AMX-220FX user manual Main MIX Level, PHONES/CONTROL Room, Presets Control

- PEAK LED

- DFX MUTE SWITCH

- VARIATIONS CONTROL

4.36 CONTROL ROOM SOURCE

4.35 2TK TO MAIN MIX

4.34 ALT 3-4 TO MAIN MIX

4.31 SOLO MODE SWITCH

4.30 POWER LED

4.29 PHANTOM LED

33

This LED indicates when the phantom power is switched on.

34

This LED indicates when the power is on in your AMX-220/AMX-220FX.

35

This button provides two modes: up for PFL (Pre-Fader-Listen) mode,down for AFL(After-Fader-Listen) mode. Engage the button, the output signal of soloed channel will be sent out after its channel fader. Release the button to enter into PFL mode, the signal of soloed channel will be sent out before its channel Fader and not affected by the PAN/BAL and fader control.

Note: The SOLO MODE switch will not be usable unless one or more channel SOLO switches have been pressed down.

4.32 MAIN MIX LEVEL 36

These two faders set the amount of signal sent both to the Main Output and the Tape Output.

4.33 PHONES/CONTROL ROOM 37

This fader sets the amount of signal sent to Control Room and Headphone.

38

Engaging this switch allows you to combine the ALT 3-4 output with the MAIN MIX, and feeds ALT 3-4 signal into Main output.

39

Engaging this button to route the 2TK IN signal into the Main Mix output.

40

You can choose to monitor any combination of MAIN MIX, ALT 3-4 and 2TK IN via these matrix switches.The ALT 3-4 is additional stereo mix bus, 2TK IN is the stereo signal coming from the TAPE IN jacks.These stereo signals will be delivered to the PHONES/CONTROL ROOM by engaging these switches. Note: when the channel's SOLO switch was engaged, then the SOLO signal will replace other signals, and also be sent to the CONTROL ROOM/PHONES.

4.37 24 BIT DIGITAL EFFECTS (For AMX-220FX Model)

- PRESETS CONTROL 41

Adjust this knob to select the right effect you wish to perform. There are total 16 options for you: several kinds of reverb, mono and stereo delay, modulation effects, and versatile two-effect combination.

42

Since you have selected the preferable effect, the next step, please go with the fine consideration, there are also total 16 variations for each preset. Each variation has been designed modifying several parameter.

43

This switch is used to activate/deactivate the effect facility. Sometimes, you can also use the DFX FOOTSWITCH for convenient operation.

44

This LED lights up when the input signal is too strong. In case of the digital effect module being muted, this LED also lights up.

16	1	2
15		3
14		4
13		5
12		6

117

10 9 8

PRESETS

16	1	2
15		3
14		4
13		5
12		6

117

10 9 8

VARIATIONS

PEAK

DFX MUTE

1.VOCAL 1

2.VOCAL 2

3.LARGE HALL

4.SMALL HALL

5.LARGE ROOM

6.SMALL ROOM

7.PLATE

8.TAPE REVERB

9.SPRING REVERB

10.MONO DELAY

11.STEREO DELAY

12.FLANGER

13.CHORUS

14.REV. + DELAY

15.REV. + FLANGER

16.REV. + CHORUS

41

42

44

43

13