Stereo TRS Jack Plug | Humminbird AMX-220FX specification

5.1 Some Final Tips on Wiring Configuration

You can connect unbalanced equipment to balanced inputs and outputs. Simply follow these schemes.

Sleeve Tip

Ring=Right Signal

Ring

Strain Clamp

Tip=Left Signal

Sleeve=Ground/Screen

Use for Headphone, Stereo Return

Sleeve Tip

Strain Clamp

Tip=Signal

Sleeve=Ground/Screen

Use for Mono Line In, Mono 1/4"Jack Plugs

Sleeve Tip

Ring=Return Signal

Ring

Strain Clamp

Tip=Send Signal

Sleeve=Ground/Screen

Use for Pre-Gain Channel Inserts

1/4" Stereo (TRS) Jack Plug

2 1

2=Hot(+)	3	1=Ground/Screen
	3

3=Cold(-)

Use for Balanced Mic Inputs

(For unbalanced use, connect pin 1 to 3)

(seen from soldering side)

2 1

2=Hot(+)	3	1=Ground/Screen
	3

3=Cold(-)

Use for Main output

(For unbalanced use, leave pin 3 unconnected)

(seen from soldering side)

Image 17

Contents

AMX-220/ AMX-220FX Do Not Remove Any Covers Power SupplyExternal Connection Preface Table of Contents Introduction Features Ready to START? AMX-220 Control Elements AMX-220FX Input Level Setting Phantom Power +48 VoltLOW CUT Switch Mono MIC/LINE Channels Equalizer MUTE/ALT3-4 Switch & LED IndicatorHI-MID9 MID-LOW10 14 2-TRACK IN/OUT Tape Solo Switch & LED IndicatorTape OUT Stereo AUX Returns AUX Return Control AUX SendsEFX to AUX1 ALT 3-4 Control Main MIX Level Presets ControlPHONES/CONTROL Room 37 24 BIT Digital Effects For AMX-220FX Model Rear Panel Description AC Input Connector Installation and Connection Stereo TRS Jack Plug Some Final Tips on Wiring Configuration Tapped Connection Direct Output Lead Modification on mono and stereo channels For the Experts WHO Want to Know More Large Hall VOCAL1VOCAL2 Large Room Small Hall Tape Reverb Small RoomPlate Spring Reverb Mono Delay Chorus Stereo DelayFlanger REVERB+FLANGER REVERB+DELAY REVERB+CHORUS System Block Diagram DSP Section Technical Specification Warranty Registration Card WarrantyReturn Notice Terms and Conditions No.1, Lane 17, Sec , Han Shi West Road, Taichung, 401 Taiwan