Hunter Fan 2A installation manual Installing the Hanger Bracket

2 • Installing the Hanger Bracket

CAUTION: To avoid possible electrical shock, before installing your fan, disconnect the power by turning off the circuit breakers to the outlet box and associated wall switch location. If you cannot lock the circuit breakers in the off position, securely fasten a prominent warning device, such as a tag, to the service panel.

2-1. Drill two pilot holes into the wood support structure through the outermost holes in the outlet box. The pilot holes should be 9/64” in diameter.

2-2. Partially install two canopy screws in the holes on each end of the hanger bracket, as shown in the figure to the right.

Hanger
Bracket
Canopy
Screw	Step 2-2

Canopy Screw

2-3.	Your fan comes with four mounting isolators. Position the
	isolators between the hanger bracket and ceiling by inserting the
	raised areas on each isolator into the holes in the hanger bracket.	Isolator
2-4.	Thread the lead wires from the outlet box down through the hole
	in the middle of the hanger bracket.	Step 2-3
2-5.	Align the slotted holes in the hanger bracket with the pilot holes
	you drilled in the wood support structure.
	Note: The isolators should be flush against the ceiling.
2-6.	Place a flat washer on each of the two 3” wood screws and pass
	the screws through the slotted holes in the hanger bracket into
	the pilot holes you drilled.
	Tighten the screws into the 9/64” pilot holes; do not use lubricants
	on the screws. Do not over tighten.
	Flat Washer
	3” Wood Screw
		Steps 2-4 – 2-6

5

42883-01 • 08/27/09 • Hunter Fan Company