Hunter Fan 30061, 30057A manual Setting Up Your Air Purifier, AIR Purifier Parts

3

Setting Up Your Air Purifier

1. Remove your air purifier from the box and take it out of the clear plastic protective bag.

2. Place your HEPAtech® Air Purifier on a firm, flat floor.

3. Before turning the Air Purifier ‘on,’ open the front grill.

•For Model 30057A, 30061: To release the front grill, press the buttons on the side until the front grill slides easily over the buttons. (Refer to Figure 1.)

•For Model 30067A, 30124A: To release the front grill, place your fingers behind the tabs and pull forward. (Refer to Figure 2.)

4. Next, check the HEPAtech® filter by pressing firmly on all four corners of the filter to ensure that it is fully inserted into the filter opening.

5. The carbon pre-filter is mounted inside of the front grill with “hook” tape. Confirm that it covers the grill vents. (Refer to Figure 3.)

6. Place the filter installation reminder sticker on the inside edge of the front grill. Circle the month and write the year of installation for the pre-filter and HEPAtech® filter.

7. Replace the filter and front grill. Be sure that the bottom grill tabs are in position first, and then push the top of the grill forward until it is closed. The unit is now ready for normal operation. NOTE: This unit will not operate unless the door is placed in the correct position.

8. Plug the unit into a 120V electrical outlet.

	AIR PURIFIER PARTS
HEPAtech®	HEPAtech®
Filter	Filter
Front Pre-Filter	Front Pre-Filter
Grill	Grill

Buttons for opening the front grill

Tabs for opening the front grill

Figure 1 - Model 30057A, 30061 Figure 2 - Model 30067A, 30124A

Hook Tape

Figure 3

Grill Vents

Hook Tape

©2010 Hunter Fan Company 08/18/2010