2 • Installing the Hanger Bracket
2-1. Drill two pilot holes into the wood support structure through the outermost holes in the outlet box, using the ceiling plate as a guide. The pilot holes should be 9/64” in diameter.
2-2. Install one canopy screw into each side of the ceiling plate as shown.
2-3. Place a flat washer on each of the two 3” wood screws.
2-4. Thread the lead wires from the outlet box down through the hole in the middle of the ceiling plate.
2-5. Align the slotted holes in the ceiling plate with the pilot holes you drilled in the wood support structure.
2-6. Pass the wood screws through the slotted holes in the hanger bracket into the pilot holes you drilled.
Tighten the wood screws into the 9/64” pilot holes; do not use lubricants on the screws. Do not over tighten.
Canopy Screw
Flat Washer
3” Wood Screw
5
41081-01 • 08/04/09 • Hunter Fan Company
