Hunter Fan 41370-01 installation instructions Steps

Steps

1.Disconnect power to the ceiling fan by turning off the circuit breakers to both the outlet box and to its associated wall switch location.

2.Remove the lower switch housing from the fan and remove the cover. (see figure 1)

3.Locate the black wire with a white stripe and the white wire in the lower switch housing. Using approved wire nut connectors, connect the black wire with a white stripe from the lower switch housing to the black wire from the light kit, then connect the white wire from the lower switch housing to the white wire from the light kit. (see figure 2)

4.Align the holes in the lower switch housing with the two partially installed screws in the top of the light kit. ese screws can be accessed through the two holes in the metal plate which sits below the light socket. (see figure 2)

5.Attach the light kit to the lower switch housing by securely tightening the two partially installed

screws. Reinstall the lower switch housing. WARNING: Improper installation could cause the light fixture to fall.

6.Install one 75 Watt max A-19 bulb into the light socket.

7.Align the four holes in the upper louver ring with the four holes in the lower louver ring. When the holes are properly aligned, the two rings will loosely lock together. (see figure 3)

				upper louver
				ring
		lower switch	partially installed
		housing
				screw
lower switch
housing
		cover
figure 1		figure 2	access	figure 3	lower louver
			holes
					ring
41370-01 rev 7-28-05.indd	3			7/28/2005, 11:38 AM