Note: If you are installing a light fixture, do NOT install the switch housing without first referring to the instructions included with the light fixture.
7-1. Align the holes on the blade iron cover and gasket and stick two screws through two of the holes.
7-2. read the plug connector from the mounting plate through the gasket and cover. Partially install the gasket and cover to the mounting plate with the two screws.
7-3. Place the upper switch housing over the two screws and turn counterclockwise so that the screws fit securely in the slots.
7-4. Partially install the third screw and then tighten all three screws securely.
7-5. Connect the upper plug connector from the motor to the lower plug connector in the switch housing assembly.
Note: Both plug connectors are polarized and will only fit together one way. Make sure the connectors are properly aligned before connecting them. Incorrect connection could cause improper operation and damage to the product.
7-6. To attach the lower switch housing, thread the thumb screws through the side holes of the upper switch housing and tighten them securely.
Note: You can customize your Hunter fan with a number of accessory light kits.
umbscrew 
Steps 7-5 – 7-6
Blade