Hunter Fan 42404-01 installation manual Installing the Light Kit

8 • Installing the Light Kit

WARNING: Use only the light fixture supplied with this fan model.

8-1. To attach the upper switch housing, partially install two housing assembly screws into the switch housing mounting plate.

8-2. Feed the upper plug connector through the center opening of the housing.

8-3. Align the keyhole slots in the housing with the housing assembly screws.

8-4. Turn the housing counterclockwise until the housing assembly screws are firmly situated in the narrow end of the keyhole slots. Install the remaining housing assembly screw into the housing. Tighten all three screws firmly.

		Steps 8-1 – 8-3
	CAUTION: Make sure the upper switch housing is securely attached
			Housing
	to the switch housing mounting plate. Failure to properly attach and			Upper
			Assembly
	tighten all three assembly screws could result in the switch housing and		Screw	Switch
	light fixture falling.			Housing
8-5. To attach the lower switch housing, connect the upper plug
	connector from the motor to the lower plug connector in the				Plug
	lower switch housing assembly.				Connector

Note: Both plug connectors are polarized and will only fit together
one way. Make sure the connectors are properly aligned before
connecting them. Incorrect connection could cause improper
operation and damage to the product.	Lower Switch
8-6. Place the lower switch housing assembly over the upper switch	Housing
housing. Align the side screw holes in the upper and lower switch
housings. Attach the lower switch housing to the upper switch	Steps 8-5 – 8-6
housing with three housing assembly screws.
		Plug
		Connec
	Housing	Detail
	Assembly Screw
11

42404-01 • 01/04/10 • Hunter Fan Company