Hunter Fan 42743-01 warranty Assembling and Hanging the Fan

3 • Assembling and Hanging the Fan

Steps 3-1 – 3-2					You can assemble your fan for standard mounting (steps 3-1 – 3-2) or
	Downrod				for low profile mounting (steps 3-3 – 3-5).
					3-1. To assemble fan to hang down from a flat or angled ceiling, insert
				Canopy	the downrod through the canopy and canopy trim ring. Feed the
					wires from the fan through the downrod.
					3-2. Loosen the set screw on the adapter to install the pipe and ball
			Canopy		assembly. Note: When the pipe and ball assembly is fully installed,
			Trim Ring		2-3 threads on the pipe will still be visible; this is normal. Securely
		Set Screw			retighten the set screw with a wrench or pliers. Skip to Step 3-6.

CAUTION: The adapter has a special coating on the threads. Do not remove this coating; the coating prevents the downrod from

Steps 3-4 – 3-5		unscrewing. Once assembled, do not remove the downrod.
Low Profile Washer	3-3.	Remove the set screw from the adapter.
	3-4.	Place the low profile washer (lip up) into the canopy. Be sure the
		green ground wire is pointing up toward the ceiling.
		Note: For low profile mounting, the downrod is replaced with the
		low profile washer. See Steps 3-3 – 3-5.
	3-5.	Align the holes in the washer with the holes in the adapter.
		Assemble securely with three #8-32 x 3/4” screws.
	3-6.	Raise the fan and place the hook on the ceiling plate through the
		U-shaped hole in the rim. Go to 4 • Wiring the Fan.
		WARNING: Fan may fall if not assembled as directed in these
		installation instructions.

#8-32 x 3/4” Screw

Step 3-6

U-shaped

Hole

Hunter Fan Company 42743-01 • 04/15/07