Operation
Initial Operation
NOTE: The power cord has a
ING PIN FROM THIS PLUG.
Air Sterilizer Maintenance
Filter Life Counters
When the
1.Remove the Air Sterilizer from its box and remove the clear plastic protective bag. Place the unit on a firm level floor.
2.Make certain the Fan Speed Control Dial is in the Off position.
2.Plug the unit into a standard household electrical outlet.
3.Turn the Fan Speed Control Dial to Medium. (You can select your desired fan speed after you verify fan operation.) The Fan should begin operating and the Power LED should illuminate. Verify fan operation by placing your hand at the top/back of the unit.
You should feel air moving. If the fan does not begin operating, go to the Troubleshoot- ing section on page 12 of this manual.
Air Sterilizer Maintenance
Main Filter Indicator (Amber, flashing)
Cleaning Your Air Sterilizer
NoteS:
•The Air Sterilizer must be unplugged during the cleaning process.
•Be sure the unit is completely dry before plugging in and using.
•Never immerse the unit in water.
Proper maintenance of your Hunter Air Sterilizer will help ensure years of trouble free service.
Follow these steps to properly maintain your Air Sterilizer:
1.Approximately every 90 days, the outside of the unit should be cleaned with a soft, damp cloth.
2.To determine when and how to clean the
Pre-Filter and Main Filter Information
To maintain proper sterilization performance, the
6 |
Fig. 3 -
Cleaning the
To access the
1.Turn off and unplug the Air Sterilizer.
2.Remove the Top Cover. Place your fingers under the Top Cover Tabs on the Top Cover’s front corners. See Figure 4a. Lift the front of the Top Cover, then pull it toward the front of the unit. See Figure 4b.
2
Top Cover Tabs | 1 |
|
Fig. 4a - Top Cover Tabs | Fig. 4b - Removing the Top Cover |
7 |
|