Hunter Fan 44665 To Stand on a Surface, Temperature Indication, Troubleshooting, Technical

Figure 8.

2.Use the provided screw to mount the Remote Sensor on a wall or other vertical surface. The back of the Remote Sensor has a Wall-Mount Indent from which it will hang from the provided screw. See Figure 9.

Wall-Mount

Indent

Figure 9.

To Stand on A Surface

1.Replace the Outer Cover as shown in Figure 10. Use the four screws to secure the Outer Cover.

Figure 10.

2.Rest the Remote sensor on the horizontal surface of your choice.

Temperature Indication

If your Remote Sensor is set to show the temperature in Celsius, the display will show the ºC indication next to the temperature. See Figure 11.

Form No. 44004-01 R030409

C

Ch TEMP

Figure 11

Temperature Measurement Range

Your Remote Sensor will show temperatures from -40ºF to 122ºF (-40ºC to 50ºC). If the temperature is greater than 122ºF (50ºC), the LCD will show “HI”. See Figure 12A. If the temperature is lower than -40ºF (-40ºC), the LCD will show “LO”. See Figure 12B.

Ch TEMP	Ch TEMP
Figure 12A	Figure 12B

Low Battery Indication

When your Remote Sensor’s battery is running low, the LCD will show the flashing Low Battery Indication to remind you to install two fresh AA Alkaline batteries at your earliest convenience. See Figure 13. At this point your Remote Sensor will continue to function normally.

Ch TEMP

Figure 13.

Depleted Battery Indication

If your Remote Sensor’s battery is depleted to the point that the LCD is showing only the flashing Low Battery Indication, as in Figure 14, your Remote Sensor has ceased functioning and will continue in this condition until two fresh

AAAlkaline batteries are installed. Without further attention, the LCD will eventually go blank.

Figure 14.

Your Remote Sensor will return to normal operation when fresh batteries are installed.

Troubleshooting

Problem: LCD is Blank.

Solution: Make certain your Remote Sensor’s batteries are 1) installed correctly, with polarities correctly positioned, and 2) fresh.

Problem: Thermostat is not showing the same temperature as the Remote Sensor.

Solution: Make certain you have the correct Remote Sensor selected at your thermostat (if you are using more than one Remote Sensor). If you require further assistance, call Hunter Fan Technical Support at 1-888-830- 1326 from 7am to 7pm Central Time Monday thru Friday and 8am to 5pm on Saturday.

Technical

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined

by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

•Increase the separation between the equipment and receiver.

•Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

•Consult the dealer or an experienced radio/TV technician for help.

Fan Co.

7130 Goodlett Farms Pkwy,

Suite 400

MEMPHIS, TN 38016

© 2009 Hunter Fan Company