Ch
TEMP
Model 44758
Remote
Sensor
Owners
Manual
Your Model 44665 thermostat can read the temperatures from up to three weath-
If you use multiple sensors, you might want to number them. Simply use a mark- er to write a number on the back of each sensor.
Additional sensors can be pur- chased separately from your HVAC contractor, or you can contact us at www.climatetechnologyproducts.com.
You can mount the Remote Sensors on a wall or other vertical surfaces, or you can set the Remote Sensors on tables or other horizontal surfaces.
Consult the Thermostat Instruction Man- ual, page 15, Option 8 for instructions in setting the thermostat to accommodate the remote sensors.
*Distance my vary based on building con- struction or other interfering frequencies.
NOTE
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, includ- ing interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digi- tal device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instruc- tions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or televi- sion reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
•Increase the separation between the equipment and receiver.
•Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
•Consult the dealer or an experienced radio/TV technician for help.
1.Remove the four screws on the back of the Remote Sensor. See Figure 1. The Outer Cover will drop off.
Outer Cover
Figure 1
2.Remove the Battery Compartment Cover, which is underneath the Outer Cover. See Figure 2.
Battery
Compart- ment Cover
Figure 2
3.Use the tip of a paper clip to set the
FIRST FOUR Remote Sensor DIP Switch- es to any configuration you desire. NOTE: Each sensor you use must have a differ- ent setting. See Figure 3.
To set the remote sensor to display the temperature in Fahrenheit, place the FIFTH DIP switch in the DOWN position.
To set the remote sensor to display the temperature in Celsius, place the FIFTH DIP switch in the DOWN position.
ON DIP
1 2 3 4 5
Figure 3
4.Install two fresh AA alkaline batter- ies into the Battery Compartment, being careful to observe the battery polarities. See Figure 4.
Battery
Compart- ment (Batteries installed)
Figure 4
OPERATION
Initial Start-Up
1.When the batteries are installed, the LCD Display will show the first initializing screen for approx. 2 seconds. See Figure
%
C
Ch
RHTEMP
Figure 5
2.The LCD Display will then show the second initializing screen for approx. 10 seconds. See Figure 6.
Ch
Figure 6
Form No.
