Hunter Fan 44830-01, 90391, 20091209 owner manual Base Assembly, Stand Fan

Base Assembly

Stand Fan

1.Slide the Telescope Rod (7) into the top of the Stand Base (8) aligning the 4 screw holes. Figure 7.

2.Secure the Telescope Rod (7) by inserting the 4 base screws(9) inot the 4 nuts placed on the bottom of the fan base and tighten securely. Figure 8.

3.Remove the Adjustment Knob(10) by twisting counter-clockwise and slide the Base Cover(11) down the Telescope Pole(7) until it covers the Screws at the Stand Base(8). Figure 9.

4.Reattach the Adjustment knob and tighten.

5.Loosen the Screw in the back of the Fan Assembly.

6.Slide the Fan Assembly onto the telescope pole of the base until it rests on the top of the pole. Figure 10.

7.tighten the screw on the back of the fan Assembly until secure.

Warning: Do not force pole into the Stand Base as damage to the Telescope Pole may occur. Do not overtighten the Base Nut or screws.

Height Adjustment

1.Grip the upper part of the telescope pole and loosen the Adjustment Knob.

2.Raise or lower the pole to the desired height.

3.Turn the Adjustment Knob until it is secure.

When adjusting the height of the fan, always grip the pole above the adjustment knob firmly to prevent the telescoping pole from collapsing.

(7)Telescope Pole

(8)Stand Base

Figure 7.

(10)Adjustment Knob

(9)Screws

Figure 8.

(11) Base Cover

Figure 9.

Figure 10.

©2009 Hunter Fan Co. 6 44830-01 20091209