Remote Battery Installation
1.Turn the Remote Control over and Remove the Battery Cover from the back by gently pressing down on the tab and sliding down on the tab. Figure 11.
2.Insert 2 “AAA” Batteries into the battery compartment, ensuring the positive and negative ends of the batteries are installed correctly.
3.Slide the Battery Cover back and snap into place.
Operation - Fan/remote
See Figure 12. for fan operation and Figure 13. for remote operation.
ON/SPEED - Turns the unit on and adjust the speed of the unit between High, medium, and low.
OSC - Sets the oscillation mode of the fan.
TIMER - Used to set the running time to 0.5 to 7.5 hours in 30 min, 0.5 increments.
Note: The digital indicators on the fan will light up to indicate the timer setting. 0.5 will light up for 30 minutes or 1H and 4H will light up to indicate 5 hours.
OFF - Turns the fan off.
Fan Indicators
L M H - Indicates the current running speed of the fan.
0.51H 2H 4H - Shows the number of hours the timer is set to run.
- Fan oscillates from left to right.
- Fan oscillates up and down.
- Fan oscillates in a figure 8 motion.
Figure 11.
0.5H 1H 2H 4H
L M H
ON l SPEED
OSC
TIMER
OFF
Figure 12.
SPEED | F |
C |
|
OS |
|
RON/OF | |
TIME |
|
Figure 13.
©2009 Hunter Fan Co. | 7 |
