Heat & Glo LifeStyle XLR-N-CE K. Battery Tray/Battery Installation, L. After Fireplace is Lit

K. Battery Tray/Battery Installation

The IntelliFire PlusTM system has a battery backup option. Battery longevity and performance will be affected by the service temperatures of this appliance. Batteries should only be used as a power source in the event of an emer- gency such as an outage.

L. After Fireplace is Lit

Initial Break-in Procedure

•The fireplace should be run three to four hours continuously on high.

•Turn the fireplace off and allow it to completely cool.

•Remove fixed glass assembly. See Section 14.E.

•Clean fixed glass assembly. See Section 3.

•Replace the fixed glass assembly and run continuously on high an additional 12 hours.

This cures the materials used to manufacture the fire- place.

NOTICE! Open windows for air circulation during fire- place break-in.

•Some people may be sensitive to smoke and odors.

•Smoke detectors may activate.

M. Frequently Asked Questions

ISSUE	SOLUTIONS
Condensation on the glass	This is a result of gas combustion and temperature variations. As the fireplace warms, this con-
	densation will disappear.
Blue flames	This is a result of normal operation and the flames will begin to yellow as the fireplace is allowed
	to burn for 20 to 40 minutes.
	When first operated, this fireplace may release an odor for the first several hours. This is caused
Odor from fireplace	by the curing of materials from manufacturing. Odor may also be released from finishing materials
	and adhesives used near the fireplace. These circumstances may require additional curing related
	to the installation environment.
Film on the glass	This is a normal result of the curing process of the paint. Glass should be cleaned within 3 to 4
	hours of initial burning. A non-abrasive cleaner such as gas appliance glass cleaner may be neces-
	sary. See your dealer.
	Noise is caused by metal expanding and contracting as it heats up and cools down, similar to the
Metallic noise	sound produced by a furnace or heating duct. This noise does not affect the operation or longevity
	of the fireplace.
	This appliance can operated on battery power in the event of a power outage. To access the bat-
Power Outages (battery backup)	tery pack, the decorative front, mesh and glass assembly must be removed. Refer to Section 12
	for more details.
Wall above appliance feels hot to	No action necessary. This appliance ships with a non-combustible material attached. Specifica-
the touch.	tions of the attached non-combustible material are listed in Section 1.E.

12 Heat & Glo • XLR-N-CE, XLR-PB-CE • 2198-900 Rev. J • 5/12