Heat & Glo LifeStyle XLR-PB-CE, XLR-N-CE manual Vent Information and Diagrams

7 Vent Information and Diagrams

A. Approved Pipe

This appliance is approved for use with Hearth & Home Technologies SLP venting systems. Refer to Section 17.B for vent component information.

DO NOT mix pipe, fittings or joining methods from differ- ent manufacturers.

The pipe is tested to be run inside an enclosed wall. There is no requirement for inspection openings at each joint within the wall.

WARNING! Risk of Fire or Asphyxiation. This appli- ance requires a separate vent. DO NOT vent to a pipe serving a separate solid fuel burning appliance.

B. Vent Table Key

The abbreviations listed in this vent table key are used in the vent diagrams.

Symbol	Description
V1	First section (closest to appliance) of vertical length
V2	Second section of vertical length
H1	First section (closest to appliance) of horizontal length
H2	Subsequent sections of horizontal length

C. Use of Elbows

Diagonal runs have both vertical and horizontal vent as- pects when calculating the effects. Use the rise for the vertical aspect and the run for the horizontal aspect (see Figure 7.1).

Two 45º elbows may be used in place of one 90º elbow. On 45º runs, one foot of diagonal is equal to 21.6 cm horizontal run and 21.6 cm vertical run. A length of straight pipe is allowed between two 45º elbows (see Figure 7.1).

Verticalcm21,6

21,6 cm

D. Measuring Standards

Vertical and horizontal measurements listed in the vent diagrams were made using the following standards.

•Pipe measurements are shown using the effective length of pipe (see Figure 7.2).

•Measurements are made from the appliance outer wrap, not from the standoffs.

•Horizontal terminations are measured to the outside mounting surface (flange of termination cap).

•Vertical terminations are measured to bottom of termination cap.

•Horizontal pipe installed level with no rise.

	Effective Height/Length
	Pipe	cm	mm
	SLP4	10	102
	SLP6	15	152
Effective
	SLP12	30	305
Height/
	SLP24	61	610
Length
	SLP36	91	914
	SLP48	122	1219
	SLP6A	5 - 15	51 - 152
	SLP12A	5 - 30	51 - 305

Figure 7.2 SLP Pipe Effective Length

E. Vent Diagrams

General Rules:

•When penetrating a combustible wall, a wall shield firestop must be installed.

•When penetrating a combustible ceiling, a ceiling firestop must be installed.

•Horizontal runs of vent do not require vertical rise; horizontal runs may be level.

Horizontal

Figure 7.1

Heat & Glo • XLR-N-CE, XLR-PB-CE • 2198-900 Rev. J • 5/12 23